Hey guys, I haven't installed a kit in one of these in a while. What modes have to be run when completing the installation? I know there is a "set developer" that has to be ran, at least i think i remember that. Also know how to reset the maint count. Is there anything else that needs to be ran in Service mode. Thanks!!
-
-
thanks!! -
You may also want to reset jam & error counters (U903, 904, 905), and I think the fuser counter will need to be reset in U167. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
If you have changed the feed rollers, then even the U901
Checking/clearing copy counts by Paper feed locations.Comment
Comment