Kyocera FS-C8025

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • brodera
    Trusted Tech

    100+ Posts
    • Aug 2009
    • 106
    #1

    [Misc] Kyocera FS-C8025

    Hi!

    I just got my first Kyocera FS-C8025.

    I get this message in the upper left corner saying: Adjusting Scanner. And my scanner light is lightning up all the time.
    bild.JPG

    //Best Regards
    Tags: inserted, km8030, kmc3232, kyocera, left, light, lightning, message, pressed, scan, scanner, snapped, time, upper
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 23008
      #2
      I came across something like this on a Falcon III once. It turned out that the top door on the DP was partly open, because someone had pried open the top door without using the release latch. The black plastic receiver through the rear frame was snapped off, and the latch was broken. If you inserted originals and pressed start the screen would display "Adjusting Scanner", the exposure lamp would light and stay lit, then stay like that unchanging until the machine was powered Off/On. If you held the door shut, the scanner adjustment completed and fed originals just fine.

      I don't know if this is applicable to what you're seeing, but to me it sounds quite similar. =^..^=
      Last edited by blackcat4866; 04-01-2011, 02:25 PM. Reason: excessive use of commas.
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • brodera
          Trusted Tech

          100+ Posts
          • Aug 2009
          • 106
          #3
          thx for reply!

          I just came back to work and was going to check the solution you said.
          went to the machine and the light is not lit.. Humm strange...

          Thanks anyway Blackcat!!!

            Comment

            • correo.tony
              Technician

              50+ Posts
              • Feb 2009
              • 72
              #4
              Check the best connection of the cable and connector DP in rear machine,

              Bye !

                Comment

                • chris@kokstadcopiers
                  Technician
                  • Jul 2014
                  • 14
                  #5
                  Re: Kyocera FS-C8025

                  Originally posted by correo.tony
                  Check the best connection of the cable and connector DP in rear machine,

                  Bye !
                  Just got a TA 3010i in. Displays Adjusting scanner when copying, is copying but copies are very faint.
                  When printing a status page it is fine.

                  Any help will be appreciated.

                    Comment

                    Previous template Next
                    Working...