CS-2550 questions

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Glen
    • Jun 2025
    #1

    CS-2550 questions

    CS-2550, in Maint. mode, 089. should allow test prints. It will give me "grayscale", 256-level only. The other tests produce blank prints. Also getting copy function but, from left to right, it begins to slowly fade. Also, unable to clear the drum count (U110). Count is displayed but not enabled to clear. There are a few other small probs, but perhaps one familiar with this CS-2550 will be able to address them.

    Thank you.......
    gallier@imt.net
    ggallier@lasercyclemt.com

    Glen
    Tags: allow, cs 2550, cs2550, familiar, one, question
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 23002
      #2
      Firmware

      I'd start with a Firmware re-flash or Upgrade as needed.
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • Sam Tofu
          Trusted Tech

          Site Contributor
          100+ Posts
          • Dec 2007
          • 130
          #3
          I agree with firmware issue. Although drum situation makes it a little different. Did you try to "clear" count before or after you put in new drum. If you had the new drum in it should have reset.

            Comment

            • Sathsayin
              Technician
              • Nov 2007
              • 21
              #4
              You cant clear the maintenance count on the drum unless it is above 150k.
              It will just show count. But will not have option untill 150 k is reached. called tech support on the same question before
              I want to choke the axxhole who designed this!!!!

                Comment

                • Glen
                  #5
                  CS 2550

                  Thank you for that tidbit of info.

                  Glen

                    Comment

                    Previous template Next
                    Working...