Dear All
DP700 there is no power. please advise any solution.
DP700 there is no power. please advise any solution.
-
-
Re: DP700 (4050) No Power
So the machine display shows a platen cover?
I'd start by powering Off, then re-seating the two connectors to the DP. If no change then re-load firmware. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: DP700 (4050) No Power
I'd also try swapping it with another from another falcon 3 to narrow down if the problem is DP based or copier side.Comment
-
Re: DP700 (4050) No Power
Have you performed a Sim 906.
Comment
-
Re: DP700 (4050) No Power
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
-
Re: DP700 (4050) No Power
What fixed it?Comment
Comment