First page leading edge issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Sudsybrew
    Technician
    • Oct 2011
    • 34

    #1

    First page leading edge issue

    We have an FS-1128 where the leading edge of the first page of any print or copy job shifts to the top of the page. All subsequent pages in the same job print/copy correctly.

    Any help would be greatly appreciated.
    I would rather be riding, talking to God than sitting in church thinking about riding.

    In wine there is wisdom, in beer there is strength, in water there is bacteria.
  • Venom
    Technical/IT Support

    500+ Posts
    • Nov 2009
    • 765

    #2
    Re: First page leading edge issue

    Originally posted by Sudsybrew
    We have an FS-1128 where the leading edge of the first page of any print or copy job shifts to the top of the page. All subsequent pages in the same job print/copy correctly.

    Any help would be greatly appreciated.
    Maybe a bad registration clutch.
    IBM, Mita, Konica Minolta, Ricoh, Kyocera, HyPAS, Canon, Oce, Samsung, HP, TEO IP PBX/Unified Communications, Comptia Network+ Comptia PDI+ Certifications

    Comment

    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838

      #3
      Re: First page leading edge issue

      This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

      Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

      Paul@justmanuals.com

      Comment

      • madas
        Trusted Tech

        250+ Posts
        • Aug 2008
        • 313

        #4
        Re: First page leading edge issue

        Hi, change the drive unit DR-150. I have seen a few m/c's using the same drive unit have this sort of problem.

        madas

        Comment

        • eddie110171
          Service Manager

          100+ Posts
          • May 2012
          • 133

          #5
          Re: First page leading edge issue

          We had one with similar problems and only 25k. We installed the low registration kit and it solved the problem. We had also ordered in the DR-150 and did not have to install it. The low registration roller was flat spotted when we took it out. Its got to be one of the 2. Good luck.

          Comment

          • Zackuth
            Trusted Tech

            250+ Posts
            • Aug 2009
            • 448

            #6
            Re: First page leading edge issue

            I had the same issue a few weeks ago. Had a parts machine and replaced the drive unit (DR-150). It solved the problem.
            If at first you don't succeed, redefine success

            Comment

            Working...