First page leading edge issue

[Sudsybrew]

We have an FS-1128 where the leading edge of the first page of any print or copy job shifts to the top of the page. All subsequent pages in the same job print/copy correctly.

Any help would be greatly appreciated.

[Venom]

Re: First page leading edge issue

We have an FS-1128 where the leading edge of the first page of any print or copy job shifts to the top of the page. All subsequent pages in the same job print/copy correctly.

Any help would be greatly appreciated.

Maybe a bad registration clutch.

[JustManuals]

Re: First page leading edge issue

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

Paul@justmanuals.com

[madas]

Re: First page leading edge issue

Hi, change the drive unit DR-150. I have seen a few m/c's using the same drive unit have this sort of problem.

madas

[eddie110171]

Re: First page leading edge issue

We had one with similar problems and only 25k. We installed the low registration kit and it solved the problem. We had also ordered in the DR-150 and did not have to install it. The low registration roller was flat spotted when we took it out. Its got to be one of the 2. Good luck.

[Zackuth]

Re: First page leading edge issue

I had the same issue a few weeks ago. Had a parts machine and replaced the drive unit (DR-150). It solved the problem.