If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
ive got a 3530 that gets jam 81 when trying to feed into finisher. machine has over 500k on it. it appears to be getting caught on the guide on the exit door. anyone been down this road before? thanx
ive got a 3530 that gets jam 81 when trying to feed into finisher. machine has over 500k on it. it appears to be getting caught on the guide on the exit door. anyone been down this road before? thanx
Check to make sure the spring on the drive arm that connects the exit unit to the drive gears on the door is attached, it's only held on there by gravity and the slightest bit of tension, so it's really easy to knock off.
Comment