Good Afternoon,
I am having a problem with a C3320i and it is jamming only on duplex and it has a 32-05 jam code. Just reaching out to see if what...
473 results in 0.0962 seconds.
-
C3320i With jam code 32-05
-
-
Biz554e J3205 jams with new exit unit
I have a customer with a 554e that is getting intermittent J3205 jams that started after I replaced the exit unit for a separate issue about a month ago.... -
C-3350i, squeaking from exit section...
I know this has been posted before, and I read up on that. But this one might need to have the exit section pulled out (not looking forward to it) because... -
Keep getting 077-130 / IOT Exit Sensor already replaced
I keep getting the 077-130 on a Xerox 550 Machine. Printing is just fine unless the Paper turns around like for Duplex.
Had first a bad Acctor inside... -
Sharp MX 3071 Setup
I have a customer that bought a Sharp MX 3071 that was never setup. I'm setting it up for him and get a L4-11 code. From what I can tell I have to install... -
Kyocera P2235 smearing and jam
Smearing and often jam at the same position. Paper has left fuser and leading edge is 5 inch or so out of the exit section.
Thanks.
... -
J93-10 Duplex Paper Jamming bizhub c454e
Single side printing is working fine. Duplex printing paper jams at reversal section. It goes to the duplex exit and then solenoid pulls the gate when... -
Jam Code
Good day, anyone with Experience on with the J050 jam code on a Rich Mono Copier. The paper Jams with a bit of it in the exit unit and most of it in the... -
E010 Jam Toshiba 3508A
I have a Toshiba 3508A that gives a E010 jam. Paper lead edge we exits the fuser and is at the first set of rollers past the fuser. I replaced the fuser... -
Kyocera ECOSYS M3655idn - exit section parts
M3655idn
Any one know a source for the rollers from the exit section fig. 8 that are listed as #516. I know the the 500 number mean they do not...Last edited by kuby; 10-06-2023, 09:26 PM. -
MX-M7570 L4-43
I have a MXM7570 that keeps throwing a L4-43 code every day or two. First I replaced paper exit cooling fans 5 and 6, no change. Then I replace the whole... -
DF-7120 stapling problem
Have a finisher on a Taskalpha 5052ci that feeds fine until you try to use the staple function. 2 or 3 sets out of 10 will get misfeed in that when it... -
Bizhub 958 3205 Jamming nightmare
This machine runs for a few months and then starts jamming like crazy. I was over there earlier today and ran approximately 2000 without any issue. Gone -
Riso image problem
I have a image problem (see pic below) riso rp3105 It is machine related meaning if I move the drum to another riso it goes away but any drum in this...
