mita print source Ai 3010

[mkopoiuy]

mita print source Ai3010

1. c730 is showing when I turn m/c on and if I open and close the front cover then goes ready to copy.

2. Second question. If I connect finisher, m/c is showing join finisher. Do i have to do something simulation.

I will appreciate who can give me advice above questions.

won kim

[10871087]

The C730 is a Broken external temperature thermistor wire - The input voltage is above 4.5 V (230 bits). Take a look at the attached page from the book.

The finisher problem is probably a broken interlock switch on the finisher. Do you have the mounting bracket on the side of the copier exit area that actuates the interlock switch?


.

[mkopoiuy]

thank you!

The C730 is a Broken external temperature thermistor wire - The input voltage is above 4.5 V (230 bits). Take a look at the attached page from the book.

The finisher problem is probably a broken interlock switch on the finisher. Do you have the mounting bracket on the side of the copier exit area that actuates the interlock switch?


.

That is more than enough.
It is helpful for me.
Thank you very much.


won kim