Hey guys looking to sell a KM-255c Whats your opinion on these Good or bad anything to watch out for?
-
-
Re: whats your opinion on Kyocera 255c
There are a few inherent bugs ... like C3200 codes (main PWB), and toner cartridges breaking and leaving bits of plastic in the machine requiring a serviceman to remove ... otherwise OK. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Comment
-
Re: whats your opinion on Kyocera 255c
The only hitch I came across is a serial number mismatch, requiring a simulation U004.
Was it a repaired PWB? Repaired PWB's are not always repaired. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: whats your opinion on Kyocera 255c
Like any other kyocera model, when they came they had some problems, but the ones comming off the line now work good.Comment
-
Re: whats your opinion on Kyocera 255c
Good little machines. Exactly what BlackCat mentioned. Rotational marks on the charge roller or drum but just the normal stuff. Only complaint we've had is when it duplex prints legal/ledger size it slows wayyyyyyyy down. Something to watch out for if going to a small church and they expect to run their bulletins quickly.Comment
-
Re: whats your opinion on Kyocera 255c
I've noticed on two of our machines that the charge roller wears out and get small bumps on them well before the life of the drum, and of course the 3200 error.....and when Blackcat mentions that it requires a service man to remove the broken plastic parts from the cartridge he isn't lying....I have long skinny arms and I can't even get my friggin hand inside back there to get those pieces....have to start removing covers to get in there...not hard...just irritating...."In a cruel and evil world, being cynical can allow you to get some entertainment out of it."
Comment
Comment