[CQ] FS-C2026MFP 1/2" lines about 1"in on 1st copy

[Guest]

First copy/print out has 1/2" streaks about 1" in from sides. looks like the calabration squares haven"t cleaned off and instead smeared like a bad drum balde. most of the time the streaks only make it 1/2 way up ( down) the page then it's clear. good print/copy after the first one. Another tech has ? already traded out all the insides with another working FS-C2026. The other machine has been sold so I can't try crossing
the drum, DV, belt, etc. I am told the problem stayed with the machine I now need to fix during all the swapping..

[HenryT2]

Re: FS-C2026MFP 1/2" lines about 1"in on 1st copy

" First copy/print "

So this is happening when you are printing, as well as when you are making a copy ?
" FIRST ? " First print of the day ? First print of any set of copies , or a print job sent ?

You did not mention ... are these streaks in color ? monochrome ? lines ?

What else has been done , other than swapping parts ?

[JustManuals]

Re: FS-C2026MFP 1/2" lines about 1"in on 1st copy

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Gar the pilot]

Re: FS-C2026MFP 1/2" lines about 1"in on 1st copy

[first copy/print of the day and in color. As I am just getting the assignment I don't know if anything besides swapping has been done,... and the other copier has been sold so no more swapping. I do beleave DV refresh has been run but other than that=?? Makes it fun to follow-up on. May also show up after a calibration cycle. Mostly I haven't had a lot of time to work on this one, always interupted with another field call.
Thanks
Gar