If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thats not a modified part, It was just made available as a separate part, at least that is what the QA says.
Its still the same part not modified
Originally posted by BeardyBloke
seems to be a common problem, as the rear springs are too strong for the holder and the shaft pops out - KM have modified the part - 302K908250 (holder middle pulley)
Figured out what was causing the creasing, on the convey unit there are 4 white pulleys. The 2 towards the rear of the unit were not moving. There are springs that hold them down. I cut the springs down 2 loops, reinstalled and tested. The creasing is gone!
thanks louis...it helped me also.....good luck......
the back Idler wheels do not spin freely.
Comment