I've currently got an FS1028MFP that prints fine, but when copying the print comes out too high up the page as if the scanner is completely out of alignment and not scanning the full length of the glass. Any suggestions on this on as I didn'nt find much help in the manual. Many thanks.
-
-
Re: FS1028MFP Scanner problem
the problem is from the DP or from glass? -
Re: FS1028MFP Scanner problem
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
paul@justmanuals.comComment
-
Re: FS1028MFP Scanner problem
This could be a rego issue which may require scanner leading edge etc to be adjusted.
In the service manual under U settings, you may need to read it for proper adjustment, if you dont have a manual ask Paul.
madasLast edited by madas; 11-17-2013, 10:14 PM.Comment
-
Check the scanner lock is not on, top left corner of the scannerComment
-
Re: FS1028MFP Scanner problem
I'll check the manual again although it didn't seem that helpful, I may have missed something. The scanner lock is definately not on, that's one of the first checks I always do.Comment
-
Re: FS1028MFP Scanner problem
first, clean and lube the scanner railsIBM, Mita, Konica Minolta, Ricoh, Kyocera, HyPAS, Canon, Oce, Samsung, HP, TEO IP PBX/Unified Communications, Comptia Network+ Comptia PDI+ CertificationsComment
Comment