[CQ] ta3550ci cyan registration .

[canonclc]

i have a 3550ci with the cyan registration about 5mm out,ive done about 30 manual adjustments and its slowly coming back.is there a way of reseting the mc reg back to default without spending another hour trying to get it completley back ?
thanks

[Eric1968]

Re: ta3550ci cyan registration .

If 30 manual adjustments won't work, I'd guess the 31st time will also fail. Make sure the firmware is up-to-date. If only cyan is out, then replace the cyan drum kit, and do all adjustments.

[canonclc]

Re: ta3550ci cyan registration .

Make sure the firmware is up-to-date. If only cyan is out, then replace the cyan drum kit, and do all adjustments.

thanks,ill check the firmware in the morning.i guess if i switch cyan with another drum the problem should move to the new colour?

[Hawkster]

Re: ta3550ci cyan registration .

Sounds like a laser issue, have replaced a couple recently due to the registration being out. When you do the auto registration is the cyan box even all the way around the test pattern?

[canonclc]

Re: ta3550ci cyan registration .

Sounds like a laser issue, have replaced a couple recently due to the registration being out. When you do the auto registration is the cyan box even all the way around the test pattern?

no its out

[Eric1968]

Re: ta3550ci cyan registration .

It also depends if the error is in the main scan or sub scan direction. Main Scan -> Laser problem, Sub Scan -> Drum problem.

[Eric1968]

Re: ta3550ci cyan registration .

thanks,ill check the firmware in the morning.i guess if i switch cyan with another drum the problem should move to the new colour?

If it's a drum issue and you switch drums, after registration adjustments, the error should move also.

[canonclc]

Re: ta3550ci cyan registration .

It also depends if the error is in the main scan or sub scan direction. Main Scan -> Laser problem, Sub Scan -> Drum problem.

main scan ,darn

[Geo]

Re: ta3550ci cyan registration .

main scan ,darn

Laser Assembly....Had the exact problem....Sorry....

[MDR24]

Re: ta3550ci cyan registration .

I'm sure that the lasers on this model are all seperate units and are interchangable. You can always swap the cyan laser with the magenta just to make 100% sure? However, it does sound more than likely that's the issue.

[Geo]

Re: ta3550ci cyan registration .

Yep all the laser assemblies are interchangeable..