KMC2525 developer replacement

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • fshead
    Service Manager

    1,000+ Posts
    • Jan 2009
    • 2356
    #1

    KMC2525 developer replacement

    i just finished looking through the kmc2525 service manual and noticed no service mode function to
    initialize a new black dev unit.
    Am I right to assume the unit initializes upon new installation.
    do you do any other calibrations after installing a new black unit?
    thnx
    Tags: None
    • robscopyr
      Technician

      50+ Posts
      • Mar 2009
      • 54
      #2
      Re: KMC2525 developer replacement

      it is in the system setting, under adjustments. I do not have one in front of me to give you the exact procedures, but if you get into the system menu (button is on the control panel) and go thru the adjustments section you should be able to find it.

        Comment

        • fshead
          Service Manager

          1,000+ Posts
          • Jan 2009
          • 2356
          #3
          Re: KMC2525 developer replacement

          Originally posted by robscopyr
          it is in the system setting, under adjustments. I do not have one in front of me to give you the exact procedures, but if you get into the system menu (button is on the control panel) and go thru the adjustments section you should be able to find it.
          thnx
          so you dont need to be in service mode.
          i only have one kyocera i service and try to stay wth ricoh line
          but as you know we all make exceptions for $$$$

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 22973
              #4
              Re: KMC2525 developer replacement

              The developer stir will be done automatically when you power up. The machine will recognize the new EEPROM.

              Once at ready you'll want to do the:
              1) In simulation U467 turn Off Auto Color Registration. Exit service mode. In simulation U467 turn On Auto Color Registration. Exit service mode.
              2) In System Menu, User Adjustment, Color Calibration, select On.
              3) In System Menu, User Adjustment, Color Registration, enter 4-digit admin code, load letter paper in tray #1, print calibration page, on the page at each group of lines select the line in color that most closely aligns with a black line, enter the number of that black line for each group, press complete when all the numbers are entered, reprint the calibration page to re-check the results (should all be at zero). Note: For aligning the yellow groups shine an ultraviolet flashlight across the yellow lines. Like magic, the yellow lines appear dark gray for easier identification. Ultravioltet flashlights are commonly found at firearm or hunting gear suppliers for tracking injured animals.
              4) In System Menu, User Adjustment, Half-Tone Adjustment, enter 4-digit admin code, follow the prompts.

              That's it. =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                • fshead
                  Service Manager

                  1,000+ Posts
                  • Jan 2009
                  • 2356
                  #5
                  Re: KMC2525 developer replacement

                  thanks..
                  i kinda figured the eprom had to trigger something to the machine.

                    Comment

                    Previous template Next
                    Working...