[CQ] MFX-3590 Dirty press roller

[ben@km]

Hello all !
I have a bunch of MFX-3590 in one location that have black build-up on the pressure roller. I've replace the fuser a few time already. If I take out the fuser and scrub the pressure roller problem goes away for a couple of weeks. Firmware is at H5A0A0, they dont use envelop mode on the fuser and more than 95% is printed on plain paper.
Waiting for suggestion, Thanks in advance.

[tee]

Re: MFX-3590 Dirty press roller

Make sure the new fusers have 2 white dots. Muratec will give you
a new one covered under warranty. We replaced about 15 under warranty.
They have had issues with these fusers .