i am facing sc 672 in mp 1350 katana machine gestetner any one can give me hints how to resolve it
-
-
Bad connection between the controller and the operation panel. Both could be broken or the wiring harness is defective. Could also be a bug in the controller firmware (RTB 6a/6b).
A few years ago I had an MP6500 with this code and it turned out to be a defective controller power supply. -
SC672 B Controller Startup Error
The line between the controller board and the
operation panel does not open correctly
when the machine is powered on, or after the
machine was powered on communication
between the controller and operation panel is
suspended.
The controller board and operation panel
could not exchange the handshake (FDH)
and acknowledge (FEH) signals within 15 s
of the operation panel reset after power on,
or after 2 retries there was no response to
the transmission line confirmation command
issued every 30 s from the operation panel to
the controller board.
• Controller board defective
• Controller board installed
incorrectly
• Operation panel harness
connection loose or incorrect
Hi,
I wanted to ask if the screen functions if the machine comes ready?
Maybe you have a problem with the electricity board.
I have training for Katana 1350
My email is sasopine@yahoo.comComment
Comment