Energy Saver Mode

[ansuman]

We have a Panasonic DP-8016 but recently when we switch on the machine,the Energy Saver Mode starts and the Machine does'nt get ready for 40 to45 minutes. I am not able to detect the problem. Can anyone solve this problem.

Ansuman,
India.

[The-Peanut]

in your user guide for full details

Function
general settings
scroll through until administrator mode (password: 000)

scroll through until energy save mode change to 1 (invalid)
press set

try that

cheers

John

[ansuman]

Thanks

John,
Let me thank you once again for your timely suggestion in solving 'PANASONIC DP 8016' energy saver mode problem.Write now I am out of the site and will get back to you soon if the problem is solved.


Ansuman
India

[pana.techn]

RE Energy Saver Mode

I think yoy may have the machine set up so as its turnes it self off at a certant time and back on at a certant time I would just turn this feature off as I never use it , only the energy save is what I use.

[ansuman]

Energy savr Mode

Dear All,
The machine doesnt switch on and we are helpless at present,
plz help to sort out the problem and the machine doesnt start and onli the energy saver switch blinks. Plz any one help to sortout the problem.


Ansuman

[pana.techn]

Energy savr Mode

OK if your M/C has a hard drive diconect it and see if it boots up thats all I can think of, well theres1 other thing, make sure your theres no keys on the keyboard that are stuck down i.e stop button etc.

[ansuman]

Energy Saver Mode

Dear All,
We hav tried each every limited tactics in the machine,
Checked properly but we are here yet to find the conclusion,
Can someone among us hav any corespondence with the Factory Production Manager to discuss the Problem.can't anyone in this world sort out a mechanical problem.Oh God plz help......Plz anyone has any idea plz mail me in suman311281@yahoo.com

Ansuman
India

[scepter2112]

Sounds to me like you have Firmware or SC pcb problem, as no machine takes 45 min to come to ready and system controller handles machine operations. Flash firmware if that fails replace SC pcb, hope is first option.

[Greg2003]

I had a DP-1520 that would not boot up, went straight into energy saver and would not come out. Tried firmware update with no luck. It ended up being the SC PCB. You may have the same type of issue.

Greg

[JVergin]

I have also seen (on the 8060 / 6030 models) where the energy saver key gets stuck. When you go to turn the machine on, since the energy saver key is stuck pressed it goes into emergency firmware recovery mode or something to that extent. Check to see if one of the keys are stuck on the control panel.

[The-Peanut]

hmm u can always try a shipment set in service mode.