Feeder jams almost every time at registration switch. Anyone have any experience with this? Do the switches ever go bad? Is there a quick fix? Anyone have a part number? TIA
-
-
The sensor or actuator may be dirty, dislodged or broken. The photosensor doesn't usually fail. -
Found some main boards bad due to not reading proper paper size from the width sensors.Why do they call it common sense?
If it were common, wouldn't everyone have it?Comment
-
Most likely the registration sensor is just dirty. When you remove the part that covers the sensor with the metal arms either side, the reg sensor looks into a hole on this part. Make sure there is no paper dust or tippex in there.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
-
clutch and reflective sensors can be cleaned can be checked by input/output sp modes and free run check on peripheral sp, all the suggestions i read were right.Comment
Comment