[Jamming] ricoh 2018d, problem jamming

[tullio]

IMG-20160115-WA0000.jpgIMG-20151229-WA0007.jpg

the jam card , exit the oven.urgent.


thank you

[NeoMatrix]

Re: ricoh 2018d, problem jamming

1. Check stripper fingers in the fuser unit(oven)are all ok.
2. Check the press roller in the fuser has not jumped out of its home position.
3. Check the main drive gear rotating the fuser unit is not cracked or spinning freely without driving.
4. Check the side door paper guide into the fuser unit is not cracked or broken. The paper guide must line up with the fuser unit when the side door is closed. If any of the guides are broken replace the whole guide assy.

5. I believe there was a lower fuser case modification to fix associate problems with the hot roller moving out of its home position.

HTH

[tullio]

Re: ricoh 2018d, problem jamming

ok . but the same problem .

[slimslob]

Re: ricoh 2018d, problem jamming

Check that the rollers in the paper exit are turning and that the flag for the exit sensor is not stuck and blocking the paper path.

[Polarbear]

Re: ricoh 2018d, problem jamming

Check that the rollers in the paper exit are turning and that the flag for the exit sensor is not stuck and blocking the paper path.

+1

Looks like the paper is forced out of the fuser, but not being fed further on, therefore the wrinkles.

[Elmo]

Re: ricoh 2018d, problem jamming

[ATTACH=CONFIG]31723[/ATTACH][ATTACH=CONFIG]31724[/ATTACH]

the jam card , exit the oven.urgent.


thank you

what weight of card are you using
as previous posters have stated it looks like it is exiting the fuser unit then getting stuck at the exit rollers
is it ok with paper