MP C6501 (aka duster producer)

[Lagonda]

Re: MP C6501 (aka duster producer)

Thanks a lot. I have only two left.
@SlimSlob: I'm using your settings also with good results. Let's see if this frimware update makes things better.

it didn't.


The last one left belongs to a political party, they deserve it.

[slimslob]

Re: MP C6501 (aka duster producer)

One other thing that I have found is that when then drum lube bars get warn down too far, waste toner will start to stack up between the cleaning blade and spreader blade causing color streaks and background. Cleaning will giver you about a week to get new lube bars, apply brush, and blades.

[skynetto]

Re: MP C6501 (aka duster producer)

Thanks a lot. I have only two left.
@SlimSlob: I'm using your settings also with good results. Let's see if this frimware update makes things better.

[slimslob]

Re: MP C6501 (aka duster producer)

Here you go........and we've only got one of these toner spewing abominations left!!

I haven't seen that bulletin before, but the adjustments look similar to those I have been making for years.
Service Program (SP) Settings.pdf

[Lagonda]

Re: MP C6501 (aka duster producer)

TSRC here in the states has the same readme for that version frimwar. I couldn't find that rtb by that RD081049f number on TSRC or esource either.........

Here you go........and we've only got one of these toner spewing abominations left!!

[Tonerbomb]

Re: MP C6501 (aka duster producer)

Downloaded today from Ricoh Portal a new Engine firmware [Version] 1.11:06 with these modifications:

Does anybody have the RTB they are talking about?

Thanks in advance.

TSRC here in the states has the same readme for that version frimwar. I couldn't find that rtb by that RD081049f number on TSRC or esource either.........

[skynetto]

Downloaded today from Ricoh Portal a new Engine firmware [Version] 1.11:06 with these modifications:

[Modifications made:]
Symptom corrected:
- Toner scattering from the development unit.
- Image density is low.
NOTE: SP setting is required for this firmware to take effect.
See RTB RD081049f for detail.

Does anybody have the RTB they are talking about?

Thanks in advance.