MPC5502 shaded line in scan

[digicor]

201605310818_0001.jpg check out this line
its not in the print and it is in both doc feed and on the glass?? anyone seen this before? I did clean all the mirrors and the lamp

[KenB]

Re: MPC5502 shaded line in scan

[ATTACH=CONFIG]33068[/ATTACH] check out this line
its not in the print and it is in both doc feed and on the glass?? anyone seen this before? I did clean all the mirrors and the lamp

That one has memory written all over it.

Try different scanning resolutions to see if it changes. If there is a memory problem, it most likely will.

If it does, try reseating the RAM, and replace if required.

[Elmo]

Re: MPC5502 shaded line in scan

Check and clean the white read strip and the lead edge of the glass underneath it, had dirt in that area cause similar fault before

[digicor]

Re: MPC5502 shaded line in scan

OK i adjusted the dpi in the scan and here are the results