If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ricoh needs to RE-ENGINEER their crappy shit!--the FOAM gathering/exit rollers are NOT durable!--pisses me off to no end! When are they going to use a rubber material that DOES NOT break down and rot!? I'd like to see somebody re-engineer and 3D print some rollers with NinjaFlex and use the cores from the old rollers! https://ninjatek.com/
---
Originally posted by Leebs14
Is it caused by worn foam exit rollers as they are worn out and it seems to be where the noise is coming from
Comment