Overbolding when print Thick type MPC 4501

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Mark Bbb
    Service Manager

    1,000+ Posts
    • Jun 2012
    • 1662
    #16
    Re: Overbolding when print Thick type MPC 4501

    Might be an indication that the fuser unit needs to be replaced.
    sleeve roller is loosen in its frame, it adjusts itself to the thickness of the paper...
    So, if it is worn the first to notice it, is when "it's brought to it's extreme (=thick 4)"
    So start with that...
    Good luck, and keep us informed (and click thanks on me when I was write (which I am ))
    Oh my, excuse me...

      Comment

      • VasileiosG
        Technician
        • Feb 2017
        • 14
        #17
        Re: Overbolding when print Thick type MPC 4501

        still haven't found smth more than it goes away via PS driver in >>>>>SOME<<<<< cases.It's not in the fusing unit checked it.
        My best guess is the firmware.When i find some time i'll install an older version or something.Thanks a lot

          Comment

          Previous 1 2 template Next
          Working...