If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
mpc3500 photoconductor units are not set correctly
Re: mpc3500 photoconductor units are not set correctly
Originally posted by NeoMatrix
It would appear that you have replaced all the problem PCU's with all new same black units or same colour units. Have you swapped the two wires in the PCU front connector to allow the correct PCU identification signals.If you modified the drum units you should have swapped the old toner sensor and place it inside the each new PCU.
There is a PCU modified chart(PDF) somewhere in the CTN forums. Have a look at the chart for the correct wire orientation.
HTH
thanks for replay
the problem gone by replacing IOB
Comment