MP4001 ADF Jamming in inverter

[TayTayTheTechnician]

^^^^ video of what it's doing.^^^^

J004 misfeed

I checked the one way bearings in the doc feed. New feed belt but I dont think that has anything to do with it. I checked to see if there were any cracked gears and couldn't find any. It is only jamming when copying duplex. It is a notoriously dusty/dirty machine.... not sure if that is pertinent info? any help would be very appreciated.

[LNorris]

Re: MP4001 ADF Jamming in inverter

Where is the paper inside the adf when it jams? is that blue guide broken?

[TayTayTheTechnician]

Re: MP4001 ADF Jamming in inverter

Where is the paper inside the adf when it jams? is that blue guide broken?

It's right in between the exit rollers, I did not notice if the blue guide was broken but it didnt appear to be. That is, it lifts and closes during jam removal without feeling wonky and visually I know the pegs that go into the front and back frame arent busted. According to a phone call from my end user, it is now jamming regardless of simplex or duplex.

[slimslob]

Re: MP4001 ADF Jamming in inverter

Your video is nice but doesn't tell us anything. You would have been better to have posted the jam code.

[TayTayTheTechnician]

Re: MP4001 ADF Jamming in inverter

Your video is nice but doesn't tell us anything. You would have been better to have posted the jam code.

HA just realized that attachment didn't save. my bad, J004 is the code.

[TayTayTheTechnician]

Re: MP4001 ADF Jamming in inverter

Your video is nice but doesn't tell us anything. You would have been better to have posted the jam code.

It's a few different codes, here is the first page of the smc also

Thanks!SKMBT_C55417082818260.pdf

[jonhiker]

Re: MP4001 ADF Jamming in inverter

Clean all of the sensors. Also, remove the rear cover and check the end of the exit roller. there is a gear back there that i have replaced before for the same issue.

[slimslob]

Re: MP4001 ADF Jamming in inverter

Lead edge of the original is catching on something in the reverse path from the exit roller to the skew correction roller. After it jams, you need to check where the lead edge has stopped. Also check the ribs on any plastic guides for burrs.

[ColinLouw]

Re: MP4001 ADF Jamming in inverter

20170829_152400.jpgHad my days with a mp4001 adf!
clean and make that black again with black permanent marker. it did solve my problem..

[TayTayTheTechnician]

Re: MP4001 ADF Jamming in inverter

Clean all of the sensors. Also, remove the rear cover and check the end of the exit roller. there is a gear back there that i have replaced before for the same issue.

I have coated all the sensors and checked the guides for obstruction. I will double check the gear! Thanks!

Sent from my LG-LS777 using Tapatalk