aficio 1013

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • slimslob
    replied
    Re: aficio 1013

    Originally posted by tcypy1961
    This would info would be also for the MP161 have 2 of theses that has similar problems with fixing???
    Thanks!!!
    Yes

    Leave a comment:


  • tcypy1961
    replied
    Re: aficio 1013

    Originally posted by slimslob
    This is a single lamp fusing unit, which there is not a separate lamp to heat the ends of the hot roller. If low power mode is set to level 3 the roller may not reach optimum temperature at the ends quickly enough. Also check fusing unit idling. If idling is off, hot roller will warn up quicker but heating may not be even and the pressure is not being heated. Idling is for when the first 1 or 2 pages are not fused completely.
    This would info would be also for the MP161 have 2 of theses that has similar problems with fixing???
    Thanks!!!

    Leave a comment:


  • Zeldaman
    replied
    Re: aficio 1013

    Hi there!
    Take the fuser apart, check the plastik-bearings of the pressure-roller. They wear out, giving the problem you described. We allways change the roller and the bearings together.
    Greetings...

    Leave a comment:


  • slimslob
    replied
    Re: aficio 1013

    This is a single lamp fusing unit, which there is not a separate lamp to heat the ends of the hot roller. If low power mode is set to level 3 the roller may not reach optimum temperature at the ends quickly enough. Also check fusing unit idling. If idling is off, hot roller will warn up quicker but heating may not be even and the pressure is not being heated. Idling is for when the first 1 or 2 pages are not fused completely.

    Leave a comment:


  • quocve
    replied
    Re: aficio 1013

    Originally posted by tcypy1961
    copier doesn't fuse the outer edges of copy for first couple of copies then does so; did it to me when I made copy after waking copier up. reasons??? everything I think of I would suspect the whole copy would be affected. Thanks!!!
    Which part did you check? Tried in SpMode (Feed or scanner)?

    Leave a comment:


  • tcypy1961
    started a topic [Misc] aficio 1013

    aficio 1013

    copier doesn't fuse the outer edges of copy for first couple of copies then does so; did it to me when I made copy after waking copier up. reasons??? everything I think of I would suspect the whole copy would be affected. Thanks!!!
Working...