SOP panels interchangeability and models

[slimslob]

Re: SOP panels interchangeability and models

Both were SOP. no it was plug and play. No firmware issues.

Never assume that firmware is not the issue. Installed firmware has been known to go bad.

[fshead]

Re: SOP panels interchangeability and models

Never assume that firmware is not the issue. Installed firmware has been known to go bad.

i was asking do i need to change FW on a SOP panel that was a working pull from a mpc401sr.
I had thought some of the FW was loaded onto the op panel itself..

[fshead]

Re: SOP panels interchangeability and models

from what i was told these are the only service mode changes needed
Then there are a couple SP modes you need to change (if I remember correctly)5748-101 and 201, turn machine off, swap the NOP for the SOP, turn back on, and then go back into SP mode and change SP 5752-001 and 1041-001 (I think those were it) . Hope this helps.

[fshead]

Re: SOP panels interchangeability and models

Both were SOP. no it was plug and play. No firmware issues.

Sent from my SM-G950F using Tapatalk

as my head clears i think your swap was SOP to SOP where as I am swapping a SOP into a machine wth NOP
panel thus the need to pre install the SOP FW b4 swapping out the NOP panel for a SOP panel.