c4502 c5502 Feedder

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tinfox
    Trusted Tech

    Site Contributor
    250+ Posts
    • Nov 2007
    • 317
    #1

    c4502 c5502 Feedder

    I just got back from a service call where the feeder is jamming. The rear side of the feeder cover is lifting up while feeding. The clip in the rear is not holding under pressure. If I slide the whole top cover asm towards the rear it will stick. I may have to put washers in the middle between the screw that lets you remove the top cover and the screw hole to keep it slide over towards the rear.

    Anyone seen this before? Can the metal be any thinner on these? Maybe they'll figure out how to make the steel on molecule thick. That'll save some cash...
    Tags: cover, rear, screw, slide, top
    • mikadonovan
      Senior Tech

      Site Contributor
      2,500+ Posts
      • May 2008
      • 2931
      #2
      Re: c4502 c5502 Feedder

      I just use a little piece or 2 of velcro/double sided tape to hold the cover down after the tab breaks off. Works great, looks good.
      NEVER ASSUME ANYTHING

        Comment

        • tinfox
          Trusted Tech

          Site Contributor
          250+ Posts
          • Nov 2007
          • 317
          #3
          Re: c4502 c5502 Feedder

          Originally posted by mikadonovan
          I just use a little piece or 2 of velcro/double sided tape to hold the cover down after the tab breaks off. Works great, looks good.
          Thank you! That's actually a great idea. On mine nothing is broken (yet). Also just to be clear on which cover I mean here is a bad pic.

          c5502feedercover.jpg

            Comment

            Previous template Next
            Working...