If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Will a toner end sensor for a MPC 1100, 1350, 3000 work on a MPC 2551. From picture sensor looks identical other than wires???
Thanks!!!
worth a try...
I might have pulled a unit from some mpc2551 i gutted..but i cant think where i put them.........
might try a mpc2050 too..same toners except a tab on btle.
Comment