Hq9000 masters creasing

[barber782]

Hi everyone,

Got a customer with a hq9000 where the masters slip and crease during a run. This makes the prints skew.
Had a look at the drum assembly and cleaned up the magnetic clamp as was quite fluffy and inky.
Checked the masters feed and can't see anything.
Does anyone know anything about these or had this problem?





Sent from my VTR-L09 using Tapatalk

[GIUBOSS]

Re: Hq9000 masters creasing

Hi everyone,

Got a customer with a hq9000 where the masters slip and crease during a run. This makes the prints skew.
Had a look at the drum assembly and cleaned up the magnetic clamp as was quite fluffy and inky.
Checked the masters feed and can't see anything.
Does anyone know anything about these or had this problem?





Sent from my VTR-L09 using Tapatalk

hello, in the meantime you had to post in the '' Digital duplicators '' section. Now
try making a master with the door open and with a flashlight to see what happens inside. Have you noticed if the roll of masters does not have something that slows rotation and if the rubber rollers are clean