LCT print alignment

[WIZARDofJOZ]

I have a pro C5100s with a LCT attached. It used to print pretty straight from the LCT but now it seems that the print is skewed a bit.
I have not changed anything...could it be the rollers or another adjustment needed?
The regular drawers print plain paper just fine.
Any Ideas???

[slimslob]

Is it all 3 LCT trays or just one of them?

[dalewb74]

i would start with pulling the rollers off and clean them. see if that makes any kind of difference. also check the paper path. are you referring to the LCT that sits beside the copier? i would also make sure that it is securely attached. maybe it got bumped and is out of alignment?

[WIZARDofJOZ]

It is the large LCT on the right side of the copier that does 13X19 Cover weight stocks (Not the paper trays)

[slimslob]

So it id the same basic single tray type LCT as used years ago on the Martini series and a few others. As such it could be subject to the same tray lift problems. The timing belt pm the side away from the lift motor would hump one tooth causing the tray yo not be level side to side. Check it with a bubble level.