If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hope you have deep pockets though, the print/scan interface and Ratio controller are not cheap.
Not sure why they don't just use standard 100/1000Mbit NICs on these wide format MFDs .
Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother
Well these are the part numbers of the two main boards (for a repair swap out).
I can't help you out on where to buy them though, a Ricoh dealership should be able to order them for you.
B8565570 PCB:Interface Board (RoHs) <---(MFD card)
B6975910 Control Board (B697-57)(RoHs) <---(PCI card that slots into the PC)
Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother
Comment