3035 grey background
Replaced dev, and hot roller inthis machine and cleaned everything as it was manky. The pcu has a mark on it so I'm replacing that tomorrow. But I can't figure out what is the cause of the background. I've done all the obvious drum earth, mag roller, t-belt, charge roller. Any input?
-
Grant me the serenity to accept the things I cannot change.
-
Could be the drum if it's old, or generic toner.
Also, if you didn't cover the entrance to the dev. unit when you initialized the TD sensor after replacing the developer, then used toner will fall into the dev. unit from the drum unit and will screw up your setting.Don't take that toner with me! -
This is often related to the charge roller. Maybe not touching tightly to the contacts.sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+Comment
-
Just to post back on this, I went in this morning cleaned out the machine again, replaced dev and filter, drum and charge roller- perfect.Thanks for the input
Grant me the serenity to accept the things I cannot change.Comment
Comment