If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
anyone know how to reset a lead edge on one of these when i print a copy it has a black strip about a 1/4 inch on every copy i do.
Is that a Blackstrip,or a Blank strip?
If it's a Blank strip, 1/4" is a bit large for the registration adjustment. Check that the clutch has been installed correctly! It could be that the clutch body restraining peg is not located in the slot on the clutch.
Comment