I had a MP.3350 making vibration noise when the making copy, the sound came from right side, either fuser area or other place I am not sure. Someone kwow where it is ?
-
-
If it's an itermittent clicky rumble, kind of like a slow fart in a bathtub then it's the fuser. Just strip it down, clean and grease the bearings and bushings, hey presto.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it. -
Take off the rhs cover and see if the noise goes away. I have had a few with this cover warped and had to put some rubber shims under it to make the noise go away. Good luck.TotoroComment
-
rhs is right hand side...
i think u should do the output check....
if it is not fusing unit..then open up back cover and see which part is turning when the noise happenComment
-
Don't forget on the Russian C5 the entire side door opens up like the Apollon, Athena and Alex. There is no interchange cover. One thing I forgot to mention too, the exit / interchange unit, toner can build up on the little white rollers in there causing an annoying noise too. Run the fusing / exit motor in output modes without the fuser in, you might get a couple of SC's but it will still run.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
-
I red in an OLD THREAD that the trouble could be the hot roller strippers; I tried to clean these pieces on a MP2000 and the rumour gone away.
Comment
-
No, the MP.3350 is bigger, fuser is different than MP2000. The noise I talked about was vibration noise , not squeky noise like Mp2000.Comment
-
I hate to bump up old posts but does anyone know what the final solution was?sigpic
Relax! This firmware injection won't hurt...but it will take 45 minutes.
Comment
Comment