initial problem was please wait reinstalled the hard drive then got a 322 code. replaced the synch pcb and it went away but i can't get rid of close indicated cover message. it doesn't specify what door to close just tells you to (close cover) . i removed the bypass tray because it wasn't recognized then reinstalled it and it showed up. i have the door switches 12042510 on order but i think it could be the hdd which is not in the parts list. ideas appreciated. thanks t
-
-
It's a Toshiba 2.5" IDE HDD (p/n B0955763).
But I would just buy a a WD or Seagate locally or online from somewhere like newegg, it will be far cheaper.- Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother - Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
-
thanks cipher.Comment
-
ok replaced the hdd and front door switches, calibrated laser and drum and i can't get rid of the close indicated cover message. does not sepcify what cover, something freeky with the bypass tray too. is there a bulletin, this one just isn't right. thanks tComment
-
There might be a fuse blown on the PSU. Check the service manual for blown fuse conditions.It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.
Hit it.Comment
Comment