Ricoh 1035

[tcypy1961]

I can't remember the exact SP # 6000 for adjusting I believe it to be alighment for duplexing when using the RADF. I could not get it to work. I drew a square on both sides of a piece of paper. When duplexing that paper as my original the copy came out with lead edge lined up and one side lined up however the trail edge and the other side were off by 2mm. Any idea's.
Thanks!!!

[YHEL23]

I can't remember the exact SP # 6000 for adjusting I believe it to be alighment for duplexing when using the RADF. I could not get it to work. I drew a square on both sides of a piece of paper. When duplexing that paper as my original the copy came out with lead edge lined up and one side lined up however the trail edge and the other side were off by 2mm. Any idea's.
Thanks!!!

SP 6006 DF Registration adjustment.
1 side to side
2 leading egde (thin original)
3 leading edge (duplex front)
4 leading edge (duplex rear)

[Voltage]

I can't remember the exact SP # 6000 for adjusting I believe it to be alighment for duplexing when using the RADF. I could not get it to work. I drew a square on both sides of a piece of paper. When duplexing that paper as my original the copy came out with lead edge lined up and one side lined up however the trail edge and the other side were off by 2mm. Any idea's.
Thanks!!!

Check in "copy/document server features" under "edit" if the default margin is not set to 2mm

[Hero Geo]

Go into system setting,
Edit features and set them to zero this will line up image