Nashuatech - 3525 paper jamming fuser exit

[sabah_karim]

Hi

Nashuatech 3525 paper jamming at fuser exit from all tray even while taking
copy count page also.Replaced fuser exit sensor no benefit.
Any tips .

sabah

[TonerMunkeh]

Rebuild the fuser with new hot roller and pressure roller. That's usually favourite.

[aabarnes1]

Where is the jam 'logged'. I agree with Toner Monkeh, rebuild fuser and clean entrance guide of any toner build up. Paper tray settings??????

[TonerMunkeh]

That's a good point actually dude. Out of position end and side fences can also cause this. I've also seen broken teeth on the interchange junction gates cause gay issues too.

[Ricohslave]

The fuser exit sensor is held in the side door above the transfer unit. This sensor looks at a square recess in the fuser unit cover. The recess can get quite dusty and cause the sensor to have a false reading causing fuser exit jams.
Also, the junction gates in the separation/exit unit can stick. The rubber pads that the actuator sits on perrish and become sticky and there are 4 idle rollers in the exit section that can get covered in hard toner and can crumble away.

[kelvin3892]

Raplce Pressure Roller