Aficio 2035(nashuatec 635)

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • copymaker
    Technician
    • Mar 2010
    • 16
    #1

    Aficio 2035(nashuatec 635)

    It's a basic unit with 2 trays. No accessories attached like sorter ,finisher and ADF etc.
    Unit shows paper jam at C,D & E but there is no paper there.However after opening the side doors, "C " cleared but D & E are still there .Please give me a tip.
    Tags: 203, 2035, 635, accessories, act, adf, aficio, attached, bypass tray, cleared, doors, etc, finisher, jam, nashua, nashuatec, paper, paper jam, service manual, shows, side, sorter, trays, unit
    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838
      #2
      This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


      Paul@justmanuals.com

        Comment

        • copymaker
          Technician
          • Mar 2010
          • 16
          #3
          I can send you the same manuals with FW and tech bul etc for free . FREE OF CHARGE NO CHARGE anyone else may contact me through copytechnet and I 'll manage to send this and many others for free. Even Paul ask for one.

            Comment

            • cobiray
              Passing Duplication Xpert

              1,000+ Posts
              • Mar 2008
              • 1199
              #4
              Take the duplexer and bypass tray assemblies off and take the cover off that is under the frame for the units. There is often a sensor that gets blocked or broken by paper scraps or improper mis feed removals.
              the savin2535 is displaying well bet the hiter lamp is not shining and the lamp had been tested o.k.please kindly help.
              Samir: No, not again. I... why does it say paper jam when there is no paper jam? I swear to God, one of these days, I just kick this piece of shit out the window.
              Michael Bolton: You and me both, man. That thing is lucky I'm not armed.

                Comment

                • gooseklr
                  Technician
                  • Apr 2010
                  • 34
                  #5
                  Chances are you "C" sensor is bad, it is notorious for failing primarily because it sits above the fuser, after time the ambient heat takes them out. It should not be throwing a "E" jam if it does not have any finisher options. Hence: No need for horizontal transport....................
                  the paper exit should exit under bridge, you may want to check user tools for paper deliverly options.
                  Last edited by gooseklr; 04-19-2010, 07:31 PM.

                    Comment

                    • mikadonovan
                      Senior Tech

                      Site Contributor
                      2,500+ Posts
                      • May 2008
                      • 2931
                      #6
                      Originally posted by cobiray
                      Take the duplexer and bypass tray assemblies off and take the cover off that is under the frame for the units. There is often a sensor that gets blocked or broken by paper scraps or improper mis feed removals.
                      This happens a lot on this model.
                      NEVER ASSUME ANYTHING

                        Comment

                        • withnail
                          Technician

                          50+ Posts
                          • Apr 2010
                          • 59
                          #7
                          Swap the interchange sensor with the one on top of the bridge unit. The base is different but can be unclipped

                            Comment

                            Previous template Next
                            Working...