[Error Code] Lanier 5631 displaying SC 422

[vonhetcchtel]

Hi,
I have a Lanier 5631 that I imported and it is displaying error code SC422. Please i need help to install this machine.
Thanks in Advance.

[TonerMunkeh]

[RRodgers]

I think the high voltage connector on the frame for the transfer belt is probably broken. I believe I've seen this problem. This connector is on the frame and NOT the door. At least the one that I saw that was broke was.

[delosangeles]

Hi,
I have a Lanier 5631 that I imported and it is displaying error code SC422. Please i need help to install this machine.
Thanks in Advance.

SERVICE CALL CONDITIONS
B017/B018 7-12 SM
No.

Definition

Phenomenon Possible Cause/ Troubleshooting Procedure

422 D PCC leak
- Timing & Condition -
When the current leak is detected
for 2 seconds, leak detection
starts 1 second after the PCC
turns on. The leak signal is
monitored twice at 1-second
intervals. When the leak condition
is detected twice continuously,
this SC is displayed.
1. Check if the

PCC unit is properly installed.

2. Replace the

corona wire if it is broken.

3. Check if the

connectors on the terminal and

high voltage supply board (T1, PCC)

are

properly connected and if the cables are
damaged.
4. Clean the

receptacle.

5. Replace

the high voltage supply board (T1,

PCC)

.

6. Replace the

I/O control board.

7. Replace the

main control board.

- Signals to Check -

[A258/A259/A260]
Leak Detection:

CN227-B1 on I/O control

Board

[B017/B018]
Leak Detection:

CN221-B1 on I/O control
Board.

Just make sure if you are checking for leak detection it's the correct connector for your model & product code on the I/O board. I believe the Lanier 5625 is B017 and the 5631 is B018.

Product code A258 / A259 / A260 are the Lanier 5706/5806/5806E

Good luck