aficio 2022 adf problem

[ponto700]

Hi,

Today i recieve one AF2022 with a problem on adf.. when client makes copies from adf the machine push the first 2 or 3 papers ok and then push 3 ou 4 papers at the same time and jamm. i already change the feed belt and pick up roller becouse the machine have more than 100k copies and they never change it and the problem still. anyone already have this problem before?
Regards.

[mikadonovan]

Be sure and replace the reverse(sep) roller, too. When worn they will cause misfeeds also.

[ponto700]

hi, sorry i forgot to mencionate that i also change the reverse roller (A859-2241).

[jonhiker]

try changing the pressure plate pad, A859 2352. it is the little cork pad located on the lift plate.

[score23]

clean all the sensors in df. i just had one this morning. then go into sp and check in the input and see if the sensors are working, i think its sp 6007...

[TonerMunkeh]

Sounds like a busted torque limiter. A294 6700.

[ponto700]

thanks to all... tomorrow i will try to check all and then i post results.
TonerMunkey, i already took one torque limiter from one machine that i use for spares to test on that machine tomorrow.
regards.

[salmandol]

Sounds like a busted torque limiter. A294 6700.

I agree. I know your walking with one tomorrow, but you can also check it by looking for cracks in the casing or by spinning it, it is usually takes some force to turn by hand, if its loose its bad.

[neergish]

Are you getting several pages at once or separate pages going through one after the other in quick succession? If so it could be a build up of dust on the registration sensor felt thingy. This can fill up with paper dust and grot and do weird things, always worth giving a clean.

Theres an arrow pointing in the general direction in the attached file.20101008120346.pdf

[nmfaxman]

I have put a small smooth velcro tape strip on the rear edge of the lift plate to cushion the bounce from the solenoid.

Worth a try, works for me.

[ponto700]

hi,

i check all sensors and all are fine...after i remove the talk limiter i check a crack on it. i put other talk limiter and the problem was solved. thanks a lot for all replys.

[Jomama46]

The drive roller for the feed belt is has a one-way inside. Replace the driver roller