MPC2500 what did I do?

[Ikon Princess]

Ricoh MPC2500 had a service code for the fuser, no big deal. Get there take out fuser remove thermo switches (accidentally drop them twice) remove thermistor wipe it down put it all together, fire it up...Different fuser code related to thermistor connector. Now my age(or hair color) starts to show, go into service mode to clear the service code, go to SP5 go to SP5801( instead of SP5810, aaugh) clear scs (sc=service code in my brain at the time). Re-boot copier I get the same code. (STUPID ME!) go back into SP mode5801 clear engine,DOH. Fire it up again and get the same service code, dissassemble fuser and tighten connector for thermistor, reassemble fire it up, no more service code, but... Re-enter info on birth certificate now color registration is off and I can't get the machine to recalibrate, it says that it can't.

[verderacer]

3.3.5 COLOR REGISTRATION
Line Position Adjustment
The automatic line position adjustment usually is
done for a specified condition to get the best color
prints.
Do the following if color registration shifts:
Do “Auto Color Registration” as follows to do the forced line position adjustment.
1. First do SP2-111-3.
2. Then do SP2-111-1.
To check if SP 2-111-1 was successful, watch the screen during the process. A
message is displayed at the end. Also, you can check the result with SP 2-194-10
to -12.

Then check >

4.1.3 LINE POSITION ADJUSTMENT RESULT
SP2-194-010 to -012 (Line Position Adjustment Result: M, C, Y)
This SP shows the number as a line position adjustment result on the LCD. It shows which
color has an error (M, Y or C).

If your getting errors then follow >

4.5.2 LINE POSITION ADJUSTMENT
When there are color registration errors on the output, do the line position adjustment as
follows.

All in the manual...

[Ikon Princess]

Thank you I will be doing a lot of reading this week-end I think.

[verderacer]

No prob... and just curious, are you in AZ also?

[Ikon Princess]

Nope, sunny CA here.

[verderacer]

For a moment there I thought you might have been somebody I used to work with...

[Ikon Princess]

Thank you so much, I read everything I could cram into my brain about this and you were dead on. Thank you so very much