ricoh mpc3000 doc feed issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • digicor
    Service Manager

    1,000+ Posts
    • Jul 2008
    • 1152

    #1

    ricoh mpc3000 doc feed issue

    the doc feeder on this machine will not pull the paper in with the lid closed, it will if you cheat it with the lid open and it rips it right in..???everythnig appears to be operating properly though,
    have watched it run, is there an issue with the pressure on the intake mecanism with the lid shut, and the clutch cant turn it properly? any answers will be gladly appreciated.
  • jonezy999
    just one copy??

    Site Contributor
    500+ Posts
    • Feb 2010
    • 952

    #2
    I have had a similar problem on this model where the ADF open/up sensor was faulty, Once the adf was loaded and the copy button was pressed, nothing would happen, no motors turned, just threw a jam message. Im not sure if this is the sensor u are cheating as that would rule out my suggestion, however, it may be of some help.
    I have not failed. I've just found 10,000 ways that won't work. ~Thomas Edison

    Comment

    • BLADE
      former propeller tester

      250+ Posts
      • Dec 2009
      • 478

      #3
      I have seen 1 or 2 clutches in the MPC 3300 DF replaced to get them going with similar fault

      Comment

      • Tonerbomb
        AutoMajical Resolutionist

        Site Contributor
        2,500+ Posts
        • Feb 2005
        • 2589

        #4
        replace the feed clutch !
        Mystic Crystal Revelations

        Comment

        • ptrflrs
          Glorified Parts Swapper

          100+ Posts
          • Dec 2010
          • 192

          #5
          feed roller clean? feed clutch sounds bad but i would replace the feed belt and white foam separation roller also just in case and check the black actuator that swings down on the bottom rear of the adf close to the left hinge
          jesus loves you! (everyone else thinks you're an assh*le)
          street cred: CompTIA A+ & Network+ Certified; Konica Minolta Gold Seal x2,
          Konica Minolta Outward ASSociate, Ricoh, Sharp, Lexmark trained

          Comment

          • JustManuals
            Field Supervisor

            5,000+ Posts
            • Jan 2006
            • 9838

            #6
            This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals


            Paul@justmanuals.com

            Comment

            • xtreme-jodi
              Technician
              • May 2010
              • 12

              #7
              replace the feed clutch !

              +1

              Comment

              • digicor
                Service Manager

                1,000+ Posts
                • Jul 2008
                • 1152

                #8
                i will replace the feed clutch! feed clutch it is!
                thanks for the help,

                Comment

                Working...