message ricoh 2018 d ?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • loverkoko
    Technician
    • Feb 2009
    • 35
    #1

    message ricoh 2018 d ?

    when copy from radf in ricoh 2018d first press messge say canot detect original size
    second press messge say load bj5s paper in trary and copy
    the photo is smaller from original
    the tray 1 is a4
    i cleande 3 sensoer but the sam any help?
    Tags: 2018, 2018d, copy, dirty, electrode, load, message, original, paper, photo, ricoh, slide, tray
    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838
      #2
      This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
      Just Manuals | The Internet's largest collection of manuals | Instant Downloads


      Paul@justmanuals.com

        Comment

        • ponto700
          Trusted Tech
          100+ Posts
          • Dec 2009
          • 144
          #3
          Originally posted by loverkoko
          when copy from radf in ricoh 2018d first press messge say canot detect original size
          second press messge say load bj5s paper in trary and copy
          the photo is smaller from original
          the tray 1 is a4
          i cleande 3 sensoer but the sam any help?
          thats becouse the metal plate from the ardf that detects the size of the paper is not making good contact. just take out the 3 screws downside of where are the 3 sensors and remove the cover. after that you will see a small metal piece (electrode plate).. just clean that and then push it a little bit to down so it can make good contact on paper size sensor board. after that close and try to make a copy. sorry for my bad english but i hope you understand. anything i can make a draw to you.
          Regards.

            Comment

            • PA5RR
              Technician

              50+ Posts
              • Aug 2009
              • 62
              #4
              Your originalsensors on the RADF are blocked with dust under the contactarea. This is a strip of metal and the contactfingers slide over it. I have encountered this problem a few times, always dirty contactfingers on the A(R)DF
              technicians are the only ones that don't trust technical stuff !

                Comment

                • loverkoko
                  Technician
                  • Feb 2009
                  • 35
                  #5
                  thank u for u i solve it thanks
                  Originally posted by ponto700
                  thats becouse the metal plate from the ardf that detects the size of the paper is not making good contact. just take out the 3 screws downside of where are the 3 sensors and remove the cover. after that you will see a small metal piece (electrode plate).. just clean that and then push it a little bit to down so it can make good contact on paper size sensor board. after that close and try to make a copy. sorry for my bad english but i hope you understand. anything i can make a draw to you.
                  Regards.

                    Comment

                    • ponto700
                      Trusted Tech
                      100+ Posts
                      • Dec 2009
                      • 144
                      #6
                      Great!!
                      Regards.

                        Comment

                        Previous template Next
                        Working...