Wrong fuser oil?

[yumacopiers]

I added Ricoh FT silicon oil to Gestetner DSC 224, I am unable to reset the out of oil code
sc 571, any ideas?

[cobiray]

Do you have oil in the oil unit? Is the oil unit plugged in (sensor harness) to the fuser?

[yumacopiers]

Yes oil is in and the sensor is pluged in. I used Ricoh FT type silicon oil.

[cobiray]

Are you resetting the code thru tech rep mode? SP 5810 to 1?

[swissriddle]

Maybe you have to much oil in the oil supply unit or the oil unit isn't installed correctly . Try to install again or change it. Don't forget to reset the SC Code (SP 5-810)

[yumacopiers]

yes I am reseting using sp5-810, haw can you have to much oil in the oil supply unit?

[cobiray]

Did you reset the PM counter? SP7804-011?

[cobiray]

Yes, SC571 is oil overflow, not oil empty. Try wicking some out or if you've got an eye dropper or syringe suck some out. You don't really need to have any more than to block the sensor on the fuser for it to reset.

[swissriddle]

Wrong sensor in the unit or using manual oil-pump by SP 1-930-001

[yumacopiers]

now I get it, thanks guys, I will take same oil out and check the PM counter