Using a SP820D fuser in a C5000

[Jomama46]

Re: Using a SP820D fuser in a C5000

::EU Fuser (Aust) ::
SPC820 printer fuser into MPC copier conversion.

Move pin 1 into pin 2 slot.
Disconnect the counter reset fuse. (Its not required.)
Reset the fuser counter manually in service mode.

You guys already knew that any way....

This is for the 811/c4500 conversion. in the 820/5000 connector, pins1 and 2 have black wires and are fixed. Pins 3 and either 5 or 6 are the destination wires. the printer version uses pin3 and 6 and for the copier it uses pins 3 and 5. I think.
The off the shelf version I pulled has blue wires in the 3 and 6 postions and the tech moved the 6 pin to the 5 pin position and it still gives a "reset printer correctly".

[Bantams]

Re: Using a SP820D fuser in a C5000

its not too difficult to just swap the entire Fuser Harness and it also prevents a recall for a loose wire causing sc5 problems

[Jomama46]

Re: Using a SP820D fuser in a C5000

its not too difficult to just swap the entire Fuser Harness and it also prevents a recall for a loose wire causing sc5 problems

Maybe you're right, Have a part number?

[Bantams]

Re: Using a SP820D fuser in a C5000

Sorry I was meaning when you remove the old fuser take the harness off that and swap it to the SPC Fuser you intend to fit.

[Jomama46]

Re: Using a SP820D fuser in a C5000

Thats an idea.