Ricoh Aficio 1065

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • brianho80
    Trusted Tech
    100+ Posts
    • Sep 2009
    • 198

    #1

    Ricoh Aficio 1065

    Always paper jam at the right side after tray pick up the paper.
    Initially, found out developer leaking out from developer tank, after doing all the cleaning at gears, clutch, feed rubber and even change a new developer tank but paper jam remain happen often.

    anyone face this problem before?
  • JustManuals
    Field Supervisor

    5,000+ Posts
    • Jan 2006
    • 9838

    #2
    This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
    Just Manuals | The Internet's largest selection of manuals | Instant Downloads

    Paul@justmanuals.com

    Comment

    • jonhiker
      Senior Tech

      500+ Posts
      • Apr 2010
      • 661

      #3
      Actually, you should have posted this in the Ricoh section of the Forum.

      However, you might need need to replace the feed unit. Developer has leaked in and maybe shorted out one of the clutches or gummed up a one way bearing.

      Comment

      • georgereth
        Technician
        • Jul 2009
        • 47

        #4
        take out each feed unit replace all the one way gears , clean the entire unit (bushings,shafts,quides etc) and finaly check also the belt and the gear in the drive motor of each feed unit

        Comment

        • Herrmann
          Senior Tech

          Site Contributor
          500+ Posts
          • Jan 2006
          • 792

          #5
          georgereth is right: cleaning the one way gears is useless, you must replace them
          If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!

          Comment

          • brianho80
            Trusted Tech
            100+ Posts
            • Sep 2009
            • 198

            #6
            Re: Ricoh Aficio 1065

            thanks for all the advise.
            i had replace the clutches, gears and one way bearing, most of the gears in paper feed unit are new.
            obviously jam is reduce but remain intermittent jam.
            Are there any setting need to be configure?

            Comment

            • Jomama46
              Field Supervisor

              Site Contributor
              2,500+ Posts
              • Apr 2008
              • 2900

              #7
              Re: Ricoh Aficio 1065

              There are 4 ows in each feed unit you should have replaced. Plus one in the middle section If you have done all of this what is the jam code? Does it jam from all trays or just one?
              Attached Files
              sigpic
              You never realize how cheap a professional is until after you let an amateur do it.
              A+; Network +; PDI+

              Comment

              • Masterchief
                Trusted Tech

                250+ Posts
                • Apr 2011
                • 280

                #8
                Re: Ricoh Aficio 1065

                after the dev spill did yoy clean the registration sensor???? Some itermit jams are also caused by a worn reg mylar... if you see white iacross the reg mylar i would suggest replacing this to solve your jamming problem
                sigpic

                Comment

                Working...