Jamming Code J014

[vargue]

Re: Jamming Code J014

look my friend this threat kick my ass it's not pretained to exit unit . try to change fuser unit for trialing only then tell me what happened

[Joel]

Re: Jamming Code J014

fuser unit replaced, conveyor belt and blade replaced, registration is good, coz when i pulled out the jammed paper the image and registration is good upon reaching the exit sensor (paper separation unit 1 as per parts manual #22 part # AWO1-0049). *nick40 could you guide me where is the fuser sensor and its part # maybe this would help or if someone have a point to point wiring diagram that would guide me to look for an open connection. i also replace the whole assembly of the exit conveyor(paper separation unit 1) still J014

[vargue]

Re: Jamming Code J014

try to detect that transfer unit is rolling and two solid conductors pluged in two springs not leak ok... better from use another transfer unit ok .i also ask yo one more time are yo replace hall fuser unit not upper or lower roller all fuser unit .

[Joel]

Re: Jamming Code J014

transfer unit is ok, i got it from a good running unit and connectors are ok, no leaks. yes i replaced the whole fusing unit assembly. still same problem J014.

[vargue]

Re: Jamming Code J014

look this is last attempt open back machine yo will be bicu which have 6switches detect that number1 and number 6 left and all switches down and tell me what happened

[nick40]

Re: Jamming Code J014

fuser unit replaced, conveyor belt and blade replaced, registration is good, coz when i pulled out the jammed paper the image and registration is good upon reaching the exit sensor (paper separation unit 1 as per parts manual #22 part # AWO1-0049). *nick40 could you guide me where is the fuser sensor and its part # maybe this would help or if someone have a point to point wiring diagram that would guide me to look for an open connection. i also replace the whole assembly of the exit conveyor(paper separation unit 1) still J014

part # AW010118, page 14 item 19.

input mode SP 5-803, Group 1, bit# 7. Check for a change of state as you block and unblock sensor.

[Joel]

Re: Jamming Code J014

sorry guys for the late reply coz im doing some field work. ok nick40 i'll try this one.

[lupi]

Re: Jamming Code J014

guys, i pulled out the unit and bought it to our shop, i had removed the scanner and copied and found that the jammed paper is upon reaching the exit sensor and the solenoids are fine they don't stick, the paper stops upon reaching the exit sensor and i replaced the exit sensor but to no avail. guys do you have any ideas on where or what is the problem of this machine? is there a wiring diagram available for this machine Ricoh aficio 2035? maybe the point to point wiring diagram would help me solve this problem.

Sir,bosing,

nasagot na nila yung tanong mo. lumagkit na nga yung pad sa solenoid lever, natunaw na. check mo spring mo baka natanggal check mo muna. pati mga harness. pero wala lang pala eh.

regards,

[Joel]

Re: Jamming Code J014

Thanks Tol lupi,
pero ok yung pad spring at mga harness nya .kc pinalitan ko yung buong assly before i seek help. pero ok din at may kasama ko pinoy d2.

[vinli]

Re: Jamming Code J014

one of the solenoid @the interchange unit timing a bit slow to activate the pawl to guide the paper, can try to clean the solenoid or change it