MPC 3500 COPY ISSUE

[georgereth]

THE COPY QUALITY IS LIGHTER 10mm IN THE BEGINING OF THE PAGE . I HAVE CLEAN THE OPTICS
NOTE I CANOT PERFORM PRINTER CALLIBRATION COPIER CALLIBRATION IS DONE
ANY IDEAS?
THNKS

[sandmanmac]

Re: MPC 3500 COPY ISSUE

Usually, if you can't do the ACC, then you may need to do the Line position adjustment in SP mode. Do the rough adjustment first, and then the fine one as follows: SP2-111-3, then SP2-111-1.
Although, I'm not sure if this would cause the lightness that you're describing, but it can't hurt to try.